2. Tape
one edge of the template to the installation surface
with masking tape and unroll it. Level the template
and tape the other edge to the installation surface.
3. Drill
1/4" holes 3 inches deep where indicated on
our template. Remove the template and clean out
all drill holes using any of the following methods:
a quick puff of air; using the vents on your drill;
compressed air or a turkey baster.
4.
Insert the studs into the
stud holes on the back of each letter. Now fill the
drill holes in the wall of the first letter with silicone.
5.
Push the tube of silicone
over each stud on the first letter in order to evenly
coat it with adhesive.
6.
Push the letter into the
drill holes using a shim to assure the proper standoff
of the letter from the wall. Repeat steps 3 through
5 for the rest of the letters.
